SpectroEye™60
2
2 • Use
○○○ ○○○○○○○○○○○○○○○○○○○○○
○○○○○○○○○○○○○○○○○○○○○○○○
If the clock runs slow, a positive
value must be entered (to speed
it up), whereas if it runs fast, this
value must be negative (to slow
it down).
○○○○○○○○○○○○○○○○○○○○○○○○
• Set time
Now select Set time menu option. Correct the settings:
- Hour
- Minute
- Second
Save the new time with Accept data.
• Clock adjustment
The clock built into the SpectroEye may be running either
slightly fast or slightly slow. If the time on print-outs
is wrong, the clock can either be reset as described
previously, or its long term speed can be adjusted.
Proceed as described in the following example:
If after four weeks, you find that the SpectroEye clock
is four minutes slow.
1. Calculate the correction factor:
in 28 days, the clock lost 240 seconds, equal to
8.6 seconds per day.
2. Select Clock adjustment from the menu.
3. Select Sec/day and enter the correction factor +8.6.
4. Save the correction with Accept data.
2.6.1.5 Battery
From main menu, select the following item
Settings > General > Battery
to detect, which type of battery is being used.
2.6.1.6 New functions
The available functions of your SpectroEye may be configured
exactly according to your needs. The functions which you did
not purchase initially may be added by inputting a special code.
When you request a new function from your dealer, you will
receive a code allowing you to include the corresponding
measurement function.
To activate one or more functions, select the following
item from the main menu
Settings > General > New functions
At this point you will be requested to enter the special code.
Once the code has been specified, the new function will
be available.
○○○○○○○○○○○○○○○○○○○○○○○○
To Next Page
Loading...