SpectroEye™ 29
2
2.3 Initial settings
When working with the SpectroEye, modification of some basic
settings are rarely done or never need to be performed. Many of
these default settings directly influence measured results, so
these settings must be reviewed immediately after deactivating
the transport protection!
The basic settings can be found in the main menu under the
Settings option. These are subdivided into General and User
defined settings. General settings are global i.e. even if the
SpectroEye will be configured for several users, these settings
will apply to all. These are maintained until they are explicitly
modified. User defined settings refer to specific applications.
If the SpectroEye is subsequently configured for various users,
these can be independently configured for each user.
2.3.1 General settings
From the main menu, first select:
Settings > General
The following settings can be modified:
• Data Interface
• LCD contrast
• Date and time
The remaining settings, such as:
• Setting protection
• Battery
• New functions
• Instrument type
• Service
• Transport protection
do not need to be defined immediately and can be reviewed
at a later time.
If the basic settings are not made
immediately, be sure to at least
check them before beginning a job.
2 • Use
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
○○○ ○○○○○○○○○○○○○○○○○○○○○○○
To Next Page
Loading...