Model 574 Programmable Counting System (PCS)
50 - GSE Scale Systems
PARAMETER # SELECTION DESCRIPTION
P5132. 13 Macro 13 will execute when
setpoint de-activates
P5132. 14 Macro 14 will execute when
setpoint de-activates
P5132. 15 Macro 15 will execute when
setpoint de-activates
P5132. * none No macro will execute when
setpoint de-activates
P5133.0 Mot'n * Ign'd Motion ignored (motion has no
effect)
P5133.1 Inhib Setpoint state not changed if
motion present.
P5134.0 Basis new # Lower De-activate Target
value is a specific value.
P5134.1 * % val The entered Lower De-
activate value for this
setpoint is a % multiplier of
another (to be specified)
variable.
P5134.2 diff The entered Lower De-
activate value for this
setpoint is subtracted from
another (to be specified)
variable
P5135. DL: * XXX.XXX De-activate value (Lower limit
if P5130 is set to between or
outside). Note if P5134 is
" val " or is " diff " then this
value is a percentage of or
difference of another value.
P5136.0 Based Var # Based on one of ten variables,
P80-P89, which are accessible
during normal operation.
P5136.1 * SPt 1 Based on one of Setpoint #1's
values.
P5136.2 SPt 2 Based on one of Setpoint #2's
values
thru thru
P5136.º SPt32 Based on one of Setpoint
#32's values
To Next Page
Loading...