GW Instek PSU Series Programming Manual

REMOTE CONTROL
53
11. Set the address of the master unit using the
F-76 parameter.
F-76 = 00~30
Set the address of the unit. It must
be a unique address identifier.
12. You can check the slaves’ addresses by using
the F-77 parameter on the master unit.
F-77 = 3
Display on each slave units the
configured address. This can show if
identical addresses have been
assigned individually to each slave
units.
13. Set the Multi-Drop setting parameter (F-77) to
Master.
F-77 = 1
Set the Multi-Drop setting to
master.
14. You can display the status of each slave unit by
using the F-78 parameter.
F-78 = 0~30
Displayed parameter: AA-S
AA: 00~30 (Address),
S: 0~1 (Off-line/On-line status).
15. Multiple units can now be operated using SCPI
commands. See the programming manual or see
the function check below for usage details.

GW Instek PSU Series Specifications

General

Brand	GW Instek
Model	PSU Series
Category	Power Supply
Language	English