Harmonic CableOS COS-RPL2 - Page 109

IMPORTANT: To be eligible for Harmonic technical support, you must use Harmonic-qualified SFP
+ modules only. All SFP+ modules used within the Ripple-2 node must be rated Industrial.
The following table lists the Harmonic-qualified SFP+ modules for the Pebble-2 and Jetty-1 modules.
An optical SFP has two LC sockets, Receive (Rx) and Transmit (Tx). The Pebble-2 module accepts only
single mode fiber optics to connect the fiber cable.
Contact a Harmonic representative for further details on available SFP+ part numbers, beyond what is
presented in the following table.
Harmonic part
number
Harmonic description Operating
temp.
(℃)
Max.
CA/F
len (km)
Freq
(THz)
WL (nm)
SFP-10G-I-ERD-
[C14–C61]
SFP+; 10G;
INDUSTRIAL; 40KM;
DWDM; CHANNEL [20–
60]
• ITU channels 14–61
-40–
+85
40 192.0–
196.0
(0.1
steps)
1561.42–
1529.55
(0.79–
0.81
steps)
SFP-10G-I-ZRD-
[C14–C61]
SFP+, 10G,
INDUSTRIAL, 80KM,
DWDM, CHANNEL [20–
60]
• ITU channels 14–61
-40–
+85
80 192.0–
196.0
(0.1
steps)
1561.42–
1529.55
(0.79–
0.81
steps)
SFP-10G-I-BIDI-
ER27
SFP+, 10G, BIDI,
INDUSTRIAL, 40KM,
CWDM 1270 NM
-40 –
+85
40 1270
SFP-10G-I-BIDI-
ER33
SFP+, 10G, BIDI,
INDUSTRIAL, 40KM,
CWDM 1330 NM
-40 –
+85
40 1330
SFP-10G-I-BIDI-
LR33
SFP+, 10G, BIDI,
INDUSTRIAL, 10KM,
CWDM 1330 NM
-40 –
+85
10 1330
SFP-10G-I-BIDI-
LR27
SFP+, 10G, BIDI,
INDUSTRIAL, 10KM,
CWDM 1270 NM
-40 –
+85
10 1270
SFP-10G-I-ER SFP+, 10G, 40KM,
1550NM, OUTDOOR
(INDUSTRIAL)
-40 –
+85
40 1550
SFP-10G-C-ER SFP+, 10G, 40KM,
1550NM, INDOOR
(COMMERCIAL)
0 - +70 40 1550
Related information
Hardware shipping bundles
109 Installation Guide
D R A F T