Chapter 8
Ordering information
Ripple-2 Nodes are typically quoted and sold as bundles, against a Product Part Number that fully
represents the exact node configuration. In addition, individual node modules may be ordered by
referencing the Product Part Numbers listed in the table below.
Supported Pebble-2 RPD/RMD options (1 per node)
Product Part Number Product Description
COS-PBL2-1X2-P-HR01 1X2 RPD
COS-PBL2-1X2-M-HR01 1X2 RMD
COS-PBL2-2X2-P-HR01 2X2 RPD
COS-PBL2-2X2-M-HR01 2X2 RMD
COS-PBL2-2X4-P-HR01 2X4 RPD
COS-PBL2-2X4-M-HR01 2X4 RMD
Jetty-1 Remote Switch (Up to 2 per node)
Product Part Number Product Description
COS-JTY1S-6T-2M-HR01 Jetty-1 6X10G R-Switch
Fin-1 SFP+ based OLT
Product Part Number Product Description
COS-FIN1-10-I-E1 10G/10G SFP+ based OLT, PR10+ optical power budget
with extended receiver sensitivity, Industrial temperature
range for outdoor/indoor operation from node and Ethernet
switch.
COS-FIN1-10-I-H0 10G/10G SFP+ based OLT, PR10+ optical power budget,
Industrial temperature range for outdoor/indoor operation
from node and Ethernet switch.
SFP+ modules
The SFP+ module type you use depends on the cable/fiber type you are using. Harmonic sells SFP+
modules that have been thoroughly qualified to operate with Pebble-2 and Jetty-1 modules.
108
To Next Page
Loading...