EU manufacturer's Declaration of Conformity
1. Follow these rules to safely disassemble an end-of-life product:
a. Disassemble equipment in a dedicated area, only after gathering the tools needed for disassembly.
b. Observe the rules for safe product disposal and recycling.
c. Recycling personnel are to wear personal protective equipment including proper eye protection,
proper hand protection, and proper breathing protection if needed.
d. Recycling personnel shall be experienced in using the proper tools required for disassembling
equipment. Untrained personnel shall not disassemble Harmonic products. Unfamiliarity with tools
can cause damage and injury.
2. Remove covers, housing, etc.
3. Remove and separate sub-assemblies (i.e. cables, metals, displays, fans, etc.).
4. Separate hazardous materials from the remainder of the material.
a. Sort hazardous materials into their different types (i.e., batteries, hazardous liquids, hazardous
solids, fiberglass, etc.).
b. Proceed with hazardous waste management processes only.
5. Identify re-usable materials/sub-assemblies and separate these from the rest of the material.
6. Identify and separate recyclable materials as per the examples below:
a. Scrap material to be sent to smelters.
b. E-waste such as displays, CPUs, cables and wires, hard drives, keyboards, etc.
c. Metals such as steel, brass, and aluminum.
d. Plastics such as fan casings, housings, covers, etc.
e. Fiber optics and plastic tubing not containing electrical or data wiring.
EU manufacturer's Declaration of Conformity
Learn more about Harmonic product regulatory compliance.
This equipment is in compliance with the essential requirements and other provisions of Directives
2014/30/EU (EMC) and 2014/35/EU (LVD).
NOTE: For specifics, about which standards have been applied, refer to the Declaration of
Conformity of the product on Harmonic website at Product Regulatory Compliance or contact
Harmonic Compliance Team at regulatory.compliance@harmonicinc.com.
Product regulatory compliance
Harmonic products are typically tested to the latest safety and electromagnetic compatibility (EMC)
specifications and test methods, and are marked with one or more of the following regulatory/certification
markings. Some of the certification markings will vary depending on what certifier was used to obtain a
certification.
Please visit Harmonic Product Regulatory Compliance page to view information on applied
safety & EMC standards and regulatory marks on Harmonic products. You can also email us at
regulatory.compliance@harmonicinc.com for assistance on regulatory compliance for Harmonic products.
117 Installation Guide
To Next Page
Loading...