Chapter 5
Configuring the Ripple-2 Node
All configuration commands are performed remotely. Contact Harmonic technical support for assistance if
needed.
All configuration settings are stored in non-volatile memory in the node itself. If any internal component,
such as a Pebble-2 module, is replaced, the new component automatically receives the replaced
component configuration. This configuration assumes the installation of a CableOS system:
Figure 5-1: CableOS system block diagram
• Configuring the Pebble-2 module
• Configuring RF
• Enabling or disabling RF ports P2 and P4
• Viewing Ripple-2 Node configuration with Show commands
• Upgrading Pebble-2 module software
• Upgrading Jetty module software
• Powering the Ripple-2 Node
57
To Next Page
