10515-0372-4200, Rev. R
10
2.2 STORAGE GUIDELINES
Store your XG-100P and batteries in a clean, cool (not exceeding 86 °F [+30 °C]), dry, and ventilated
storage area.
2.3 BASIC SETUP
2.3.1 Assemble the Radio
Only use a Harris charger approved for the battery chemistry. Injury could occur
from improper charger use.
Do not over-tighten the antenna as damage could result.
1. Make sure batteries are charged per charger manual 10515-0372-4010 (supplied with the charger).
2. To attach optional belt clip, remove the existing tab from the back of the radio above the battery
compartment. Slide the belt clip into the groove.
3. Lift clip, if installed, and slide top of battery into top of battery compartment at the rear of the radio.
4. Press down on bottom side of battery until it snaps into place.
5. Radio may need to be set for battery type (refer to Section 4.6.6).
Figure 2-1: Radio Assembly
To Next Page
Loading...
