10515-0372-4200, Rev. R
81
• Select Group Set – Select the channel/group bank. If your system has more than 48 channels, this
allows you to select a channel group with channels 49-96, 97-144, etc.
• Drop Call – Drop or terminate any group call that the radio receives.
• Send Status – Sends a pre-configured status. See Section 4.8.1 for more information.
• Send Message – Sends a pre-configured message. See Section 4.8.2 for more information.
• Monitor/Clear – Temporarily turn off selected squelch to monitor for traffic that may not normally
break squelch. Also, press this button followed by the emergency button to clear an emergency.
5.5.2 Programmable Ø/O Switch
The programmable Ø/O switch can be programmed for multiple functions, including:
• Switch between encrypted and unencrypted operation.
Ø – Secure (PVT Enabled).
O – Clear (PVT Disabled).
• TX Disable - Switches between Transmit Enable/Disable.
Ø – Transmit is disabled.
O – Transmit is enabled.
• Enable/Disable Talkaround.
Ø – Talkaround is enabled.
O – Talkaround is disabled.
• Lock/Unlock the Keypad.
Ø – Locks the keypad.
O – Unlocks the keypad.
• Start/Stop Scan.
Ø – Starts Scan.
O – Stops Scan.
5.5.3 Programmable A/B/C Switch
In XGP R3A and later, the A/B/C switch can be programmed for multiple functions using RPM R10B or
later.
Single-Instance Features:
Single-instance features can only be assigned to one switch position at a time. If one of these features is
programmed to the A/B/C switch, other means of accessing that feature are disabled (i.e., two-position
switch, shortcut menu, programmable buttons, call menu, etc.).
• Talkaround (Conventional Systems Only) – See Section 3.18.
• Scan – Enables scanning.
• Tx Power High – Sets transmission power level to High.
To Next Page
Loading...
