Harris Unity XG-100P - 4.7 SET UP SCAN; 4.7.1 Home, Priority 1, and Priority 2 Channels; 4.7.1.1 Home Channel; 4.7.1.2 Priority 1 Channel

10515-0372-4200, Rev. R
61
battery attached to rear of radio is clamshell containing disposable AA alkaline
batteries.
• PRIMARY LITHIUM - For accurate battery indication on front and top
displays, if battery attached to rear of radio is clamshell containing disposable
AA lithium batteries.
If smart battery is detected, SMART is displayed and you will not be able to change the
setting. Smart battery shows information such as voltage level, percent charge,
chemistry, and charging state.
4. Use to exit menu.
4.7 SET UP SCAN
These procedures are used to set up the scan list, home channels, and priority channels. Refer to Section
3.22.
1. At main display, press to access the main menu.
2. Use to highlight and select SCAN, or press .
3. Use to highlight and select SCAN LISTS and refer to the following sections.
When using Preemptive Priority Scan, the frequencies in the list need to be unique.
4.7.1 Home, Priority 1, and Priority 2 Channels
4.7.1.1 Home Channel
This is the channel you transmit on by default when you press PTT while the radio is actively scanning
and is not responding to a just received call. Responding to a call the radio just received while scanning is
called hang time. If hang time is set to 0 in RPM, the radio always transmits on the home channel in scan.
4.7.1.2 Priority 1 Channel
This channel will be scanned more often than other channels in the list and will be scanned in between
every other channel in the scan list. An example scan sequence would be P1 (priority 1), C2, P1, C3, P1,
NOTE