10515-0372-4200, Rev. R
101
A.3 MDP PPP CONFIGURATION (WINDOWS XP)
A.3.1 Windows XP Modem Configuration
The following configures a modem that will be used for the PPP connection on a Windows XP Mobile
Data Peripheral.
1. Open the Control Panel (Start
SettingsControl Panel).
2. Select Phone and Modem Options.
3. Choose Modems tab.
4. Select Add button.
5. Choose “Don’t detect my modem; I will select it from a list.”
6. Choose Next >.
7. Choose the [Standard Modem Types] that corresponds the speed of the radio as configured in the
RPM. For a 19200 bps connection, choose Standard 19200 bps Modem. Choosing a modem speed
faster than the over-the-air bit rate removes the overhead incurred by PPP layer framing.
8. Choose Next >.
9. Choose the port the radio is connected to.
To Next Page
Loading...
