10515-0372-4200, Rev. R
110
4. Since SLIP does not allow dynamic address assignment, select Internet Protocol (TCP/IP) and
choose Properties.
5. Specify the IP address after consulting with the system administrator.
6. Choose OK.
7. Choose OK.
A.3.4 Windows XP Route Configuration Notes
1. After the PPP has connected run the following commands:
The italicized IP address (i.e.,
10.1.100.209) is the radio’s RF IP address as
configured in RPM and the site. The bold IP address (i.e.,
submask built off of the radio’s PPP IP address.
a. route add 199.81.106.0 MASK 255.255.255.0 10.1.100.209 /p
b. ping 199.81.106.100 -n 1
2. Description of commands:
a. This route addition allows access to GPS over PPP. The RPM defaults to this nonce IP address.
If RPM specifies something different, this will need to be updated. The “/p” makes the IP
address permanent.
b. The ping should work.
Unity MDT’s RF
IP Address
To Next Page
Loading...
