Harris Unity XG-100P - 3.30.2 Receiving an Emergency Call; 3.30.3 Stealth Emergency; 3.31 ENCRYPTION BAR

10515-0372-4200, Rev. R
40
3.30.2 Receiving an Emergency Call
When receiving an Emergency Call, an alert beep sounds (if tones are enabled) and an emergency
indication is displayed.
Depending on options selected in RPM, the unit ID or unit name may be displayed.
While the emergency display is active, press PTT to respond to the emergency caller.
3.30.3 Stealth Emergency
The radio can be programmed with the following emergency behavior:
• No audio indications when declaring an emergency.
Or
• No visual indications when declaring an emergency.
Or
• No audio and no visual indications when declaring an emergency.
During stealth mode, the radio will not receive any type of call. Once the user presses the PTT button, the
radio display and audio returns to normal.
3.31 ENCRYPTION BAR
The encryption bar is shown in Table 3-4. Encryption keys must be loaded (Section 4.1.2) for these
indications to be displayed.
Table 3-4: Encryption Bar Indications
DISPLAY DESCRIPTION
This is an example of a key name of an AES and a DES key being
transmitted or received.
Encryption key assigned to channel was not found.
This message appears on receive radios. Encryption key assigned to channel
was not used on transmitting radio.