Harris Unity XG-100P - 3.13 TURN ENCRYPTION ON OR OFF

To Next Page

To Previous Page

10515-0372-4200, Rev. R

3.13 TURN ENCRYPTION ON OR OFF

If programmed for encryption, use to set encryption:

Ø – Secure (Encryption Enabled)

O – Clear (Encryption Disabled)

See Table 3-1 for the various options that can be programmed to the switch.

Turn encryption on or off via the Security Menu:

1. At main display, press to access the main menu.

2. Use to highlight and select SECURITY, or press .

3. Use to highlight

and enable/disable encryption. This option is grayed out if

is programmed for encryption

, or if Encryption Mode in the radio’s

personality is programmed “Forced On.”

• If a channel is programmed to be encrypted, a key icon appears on the main display when encryption

is enabled. The system must also be programmed to be encrypted.

• When encryption is turned on and you use any channel not configured for encryption, the radio allows

PTT. The signal is transmitted unencrypted.

• Systems configured for Global Encryption (enabled in the Security menu) will display a Global

Encryption icon instead of a key icon (Section 4.1.4).

NOTE

Other manuals for Harris Unity XG-100P