10515-0372-4200, Rev. R
23
If your system has more than 48 channels, the SEL CHAN/GRP option available from
the shortcut menu, allows you to select a channel group with channels 49-96, 97-144,
etc. See Section 3.34 for more information.
3.11.2 Manually Enter Channel Number
To manually enter a channel using the radio keypad:
1. Select CHANNEL ENTRY from the Shortcut Menu (this menu option must be programmed to the
shortcut menu using RPM R10B or later).
2. Enter the channel number. You can enter raw numeric index or bank letter and channel number (e.g.,
B18 and 66 will both select channel 66). To enter the bank letter, press while the cursor is on
the first digit to cycle through 2/A/B/C.
Entering a number greater than the maximum number of entries in the selected zone will select the last
channel. From the radio’s perspective, channels entered in this manner are not treated any differently
from channels selected by the channel knob; for example, the scan list will be adjusted to add the channel
(and make it P1 if applicable), emergencies will go out on the entered channel, etc.
Physically moving the channel knob or changing the system causes the radio to select
the channel indicated by the channel
knob position (in other words, subsequent
channel changes are not made with respect to the manually entered channel).
3.12 LOCK/UNLOCK KEYPAD
The A/B/C switch can be programmed to lock/unlock the keypad (requires XGP R3A or later and RPM
R10B or later).
Or
If programmed for keypad lock/unlock, use :
Or
Lock or unlock the keypad via the shortcut menu (Section 3.34). Use to unlock keypad. Make sure the
exact sequence of ◄, ►, ▲, and ▼is used. Power cycling the radio will not unlock the keypad unless
RPM setting for Power Up Options is enabled.
See Table 3-1 for the various options that can be programmed to the switch.
To Next Page
Loading...
