Harris Unity XG-100P - A.3.3 Windows XP PPP or SLIP Configuration

10515-0372-4200, Rev. R
104
18. The following dialog is displayed:
19. Choose either Cancel or Properties. If Properties is chosen, proceed with Section A.3.3,
Configuring a PPP Dial-up Connection, step 3.
A.3.3 Windows XP PPP or SLIP Configuration
Configuring a PPP Dial-up Connection
PPP connection is preferred over SLIP in most windows configurations as it allows for
dynamic address assignment from the radio as well as frame validation.
1. Open the Control Panel (StartSettingsControl Panel).
2. Select the Dial-up connection that was just created.
NOTE