Harris Unity XG-100P - A.2 RADIO CONFIGURATION

10515-0372-4200, Rev. R
100
A.2 RADIO CONFIGURATION
1. Use RPM to configure Unity MDT services, PPP IP address, and RF IP address.
2. Within Data Options  Data Interfaces tab, enable MDT and configure the MDT’s PPP address:
3. Within the Data Options, Data Transport tab, configure the MDT’s RF IP
1
.
1
If the MDP will be configured to have the radio provide the IP address (dynamic PPP IP address assignment), it is important
to set the RF IP Address even if the site will dynamically assign it. Otherwise, the radio will fail PPP negotiation until the
radio has registered with the site.
Enable MDT Services
Unity MDT’s PPP IP
Address
MDT Modem
Configuration
Unity MDT’s RF
IP Address