10515-0372-4200, Rev. R
17
3.4 STATUS MESSAGES
During radio operation, various radio Status Messages may be displayed. The messages are described
below.
Table 3-3: Status Messages
PTT DENIED
P25 Trunked only - Indicates the radio or talkgroup is not authorized to operate on the
selected system and/or talkgroup.
CALL QUEUED P25 Trunked only - Indicates the system has placed the call in a request queue.
SYSTEM BUSY
P25 Trunked only - Indicates the system is busy, no channels are currently available, the
queue is full, or an individual call is being attempted to a radio that is currently
transmitting.
SCANNING Indicates the radio is scanning.
TX EMERGENCY P25 modes only - Indicates an emergency call is being transmitted.
RX EMERGENCY
P25 modes only - Indicates an emergency call is being received. If programmed via RPM,
radio will display the unit name or unit ID.
WIDE AREA SCAN
P25 Trunked only - Indicates the radio has entered the Wide Area Scan mode to search
for a new system (if enabled through programming).
INVALID TALKGROUP
P25 Trunked only - Indicates the current talkgroup is not valid for the current system. This
could happen if the site denies registration due to an unrecognized talkgroup ID.
INVALID UNIT P25 Trunked only - Indicates the current unit is not valid for the current system.
REGISTERING
P25 Trunked only - Displayed when the radio is performing a registration/affiliation on a
P25 trunking site.
CTRL CHANNEL SCAN
P25 Trunked only - Indicates the control channel is lost and the radio has entered the
Control Channel Scan mode to search for the control channel (usually out of range
indication). The length of time before the radio enters CC Scan after losing
communication with the Control Channel is configurable in RPM.
BAND SCANNING
P25 Trunked only - This message is only displayed if the P25T system is configured for
"EnhancedCC" mode of operation. When the radio cannot find a Control Channel in either
the trunked frequency set or the list of discovered adjacencies, the radio is able to perform
a full spectrum frequency scan to find a new Control Channel.
PROFILE
SUCCESSFUL
P25 Trunked only - A new mission plan was written to the radio by ProFile Manager and
activated.
OTAR REKEYING OTAR Rekey operation is in progress.
OTAR REKEY
COMPLETE
OTAR Rekey operation completed successfully.
To Next Page
Loading...
