10515-0372-4200, Rev. R
22
3.9 PTT OPTIONS
The radio can be programmed via RPM with one of the following PTT options:
• Radio and Accessory – In this mode, when the radio is PTT’d the audio source will correspond with
the PTT source.
If the source of PTT is radio, the audio is routed via the radio microphone.
If the source of PTT is an external microphone accessory, the audio is routed via the external
microphone accessory.
• Accessory Only - Any PTT input will have the audio routed through the external microphone
accessory.
The Bluetooth Speaker/Mic is unaffected by this setting. PTTing the Bluetooth
Speaker/Mic always results in audio being routed via the Bletooth Speaker Mic.
3.10 VOICE ANNUNCIATION
When enabled via programming, the Voice Annunciation feature provides audible feedback for various
radio operations. The radio can be programmed to play an audio message for any or all of the following.
This message can be a pre-recorded (canned) message or a user-recorded message.
• Zone changes
• Channel changes
• System changes
• Encryption On/Off
• Noise Cancellation On/Off
• Scan On/Off
• Talkaround On/Off
For more information on configuring the radio for Voice Annunciation, refer to the Voice Annunciation
Feature manual 14221-7200-6110.
3.11 SELECT CHANNEL AND BANK
3.11.1 Using Group/Channel Knob
The XG-100P can be programmed with 1000 channels per system, with 16 channels in each of the three
banks.
• Bank A - Channel A1 - A16
• Bank B - Channel B1 - B16
• Bank C - Channel C1 - C16
Use the group/channel knob to select group/channel 1 – 16. Use the bank selector to set bank.
The selected bank is indicated on the display.
To Next Page
Loading...
