Harris Unity XG-100P - 3.23 TELEPHONE INTERCONNECT CALLS (P25 TRUNKED ONLY); 3.24 DTMF; 3.25 START SCAN

10515-0372-4200, Rev. R
34
3.23 TELEPHONE INTERCONNECT CALLS (P25 TRUNKED ONLY)
1. At main display, press to select MENU.
2. Use to highlight and select CALL, or press .
3. Use to highlight and select PHONE CALL.
4. Select SYSTEM LISTING to select from a list of pre-programmed numbers for
the active system, select USER LISTING to select from a list of user-defined
numbers for all systems, or select DIRECT DIAL to enter the number directly.
Direct Dial entry can have up to 31 characters (0-9, *, #
, or a space; the space
correlates to a pause.)
5. Press PTT to initiate the phone call.
6. Use to select END CALL.
3.24 DTMF
The XG-100P supports the transmission of DTMF tones corresponding to the numbers/characters on the
keypad. To overdial numbers/characters, press and hold the PTT button, and then press the corresponding
keys one at a time on the keypad. Valid keys for DTMF tones are: (1, 2, 3, 4, 5, 6, 7, 8, 9, *, 0, and #).
DTMF tones will only play if the current system is programmed for DTMF (part of
general System configuration).
3.25 START SCAN
This procedure assumes that the scan list has been added and the radio is not in active scan. Refer to
Section 4.7 for scan setup or Section 3.26 for stopping scan. Refer to Section 4.7.1.1, Section 4.7.1.2, and
Section 4.7.1.3 for home and priority channel descriptions.
Refer to Section 3.34 to start scan from the shortcut menu.
NOTE
NOTE