10515-0372-4200, Rev. R
63
4.7.4 Edit Scan List
Depending on the scan list options selected in RPM, you may be able to add or remove channels/groups
from the scan list.
1. Enter Set up Scan (see Section 4.7).
2. Use to highlight and select the scan list. Use to select VIEW/EDIT.
3. Use to highlight channel/group.
4. Use to select OPTIONS.
5. Use to select ADD CHAN/DELETE CHAN, SET PRI1, SET PRI2,
REMOVE PRI, or NUISANCE/ADD BACK.
When a channel is not grayed out in the list, DELETE
appears. When a channel/group is grayed out (not in list), ADD CHAN appears.
6. Use to toggle selection.
7. Use to exit list.
8. Use to exit scan list.
4.7.5 Set or Remove Priority 1 and Priority 2 Channels
Priority channels are scanned more often than non-priority channels. Note that P1 and P2 can only be set
if configured as “Keypad” and the scan list is not set to “Fixed” in RPM.
1. Enter Set up Scan (see Section 4.7).
2. Use to highlight scan list.
3. Use to select VIEW/EDIT.
To Next Page
Loading...
