Harris Unity XG-100P - 3.30 EMERGENCY OPERATION; 3.30.1 Declaring an Emergency Call

10515-0372-4200, Rev. R
39
You can observe GPS status:
• GPS DISABLED - GPS is disabled via programming.
• GPS TRACKING -
GPS has acquired satellite signal. GPS time
appears on top of display.
• GPS SEARCHING - GPS has not acquired. Harris logo appears on
top of display if GPS has not tracked after last power up of the radio.
• LAST KNOWN POS -
Radio was tracking and then lost GPS
signal. The information displayed is from the last known position.
3. Use to select NEXT to view satellite information.
4. Use to select BACK and exit GPS screens.
3.30 EMERGENCY OPERATION
The XG-100P can be programmed to enable emergency mode. Unit name displays on dispatcher console
if an emergency signal is received from another XG-100P on a digital channel.
3.30.1 Declaring an Emergency Call
1. Press and hold the emergency button on the radio or the speaker microphone. The
length of time you need to hold the button is configured in RPM.
Radio software R4A and later is needed to declare an emergency
from the 12082-0681-01 Bluetooth speaker microphone.
• For digital channels, the radio transmits the talkgroup or radio ID to the dispatch
console and receiving radio.
• The radio can be programmed to have a dedicated emergency
channel, which
can get activated from analog or digital channels.
• The radio can also be programmed to send an Emergency Alarm in addition to
or in place of the emergency call (P25 modes).
• The radio will go through transmit and receive cycles if configured. Speak into
the microphone while the radio is transmitting or press PTT to talk.
2. To exit emergency, power cycle the radio or select EXIT EMERGENCY from the
CALL menu.
I
f enabled via programming, you can clear an emergency by pressing the
Monitor/Clear button (top side button by default) and then the emergency button.
NOTE