10515-0372-4200, Rev. R
75
5. PROGRAMMING
This section provides information on front panel programming. Programming can also be accomplished
by creating a personality using a computer with RPM version R9A or later installed.
5.1 PROGRAMMING VIA RPM
Radio Personality Manager (RPM) is used for the bulk of programming the XG-100P. With RPM, you
can fully program the XG-100P using cable 12082-0410-A1.
Ensure that the radio is turned off before connecting the programming cable. After the
cable is connected, then power on the radio.
5.2 BLUETOOTH CLONING
Unity radios with R4A and later firmware support wireless cloning via Bluetooth. Cloning is the ability to
fill the configuration or reconfiguration of one radio using another. See Section 4.6.4 for instructions on
enabling Bluetooth on the radio.
STEP 1:
To clone a Mission Plan, the receiving radio must first be discoverable:
1. At main display, press to access the main menu.
2. Use to highlight and select PROGRAM, or press .
3. Use to select the CLONE PLANS tab and select OPTIONS.
4. Select RECEIVE CLONE.
To Next Page
Loading...
