HIKVISION iDS-9000HQHI-M8/S Series - Chapter 6 Event; Normal Event Alarm; Configure Video Loss Alarms; Configure Video Tampering Alarms

Chapter 6 Event
6.1 Normal Event Alarm
6.1.1 Congure Video Loss Alarms
Video loss detecon detects video loss of a channel and takes alarm response acon(s).
Steps
1.
Go to System → Event → Normal Event → Video Loss .
2.
Select a camera.
3.
Check Enable.
4.
Set the arming schedule. Refer to
Congure Arming Schedule .
5.
Set linkage
acons. Refer to Congure Linkage Acons .
6.1.2
Congure Video Tampering Alarms
Video tampering detecon triggered an alarm when the camera lens is covered and takes alarm
response acon(s).
Steps
1.
Go to System → Event → Normal Event → Video Tampering .
2.
Select a camera.
3.
Check Enable.
4.
Set the video tampering area. Drag on the preview screen to draw the customized video
tampering area.
5.
Set
Sensivity (0-2). 3 levels are available. The sensivity calibrates how readily movement
triggers the alarm. A higher value more readily triggers the video tampering detecon.
6.
Set the arming schedule. Refer to Congure Arming Schedule .
7.
Set linkage acons. Refer to Congure Linkage Acons .
6.1.3
Congure Sensor Alarms
Set the handling acon of an external sensor alarm.
Steps
1.
Go to System → Event → Normal Event → Alarm Input .
2.
Select an alarm input item from the list and click .
3.
Select the alarm input type.
4.
Edit the alarm name.
Digital Video Recorder User Manual
82