HIKVISION iDS-9000HQHI-M8/S Series - Configure Linkage Actions; Configure Auto-Switch Full Screen Monitoring; Configure Buzzer

5.
Click Apply to save the sengs.
6.4 Congure Linkage Acons
Alarm linkage acons will be acvated when an alarm or excepon occurs.
6.4.1 Congure Auto-Switch Full Screen Monitoring
When an alarm is triggered, the local monitor displays in full screen the video image from the
alarming channel congured for full screen monitoring. And when the alarm is triggered
simultaneously in several channels, you must
congure the auto-switch dwell me.
Note
Auto-switch will terminate once the alarm stops and back to the live view interface.
Steps
1.
Go to System → Live View → General .
2.
Set the event output and dwell
me.
Event Output
Select the output to show the event video.
Full Screen Monitoring Dwell Time
Set the
me in seconds to show the alarm event screen. If alarms are triggered
simultaneously in several channels, their full-screen images will be switched at an interval of
10 seconds (default dwell
me).
3.
Go to the Linkage Acon interface of the alarm detecon (e.g., moon detecon, video
tampering, face detecon, etc.).
4.
Select the Full Screen Monitoring alarm linkage
acon.
5.
Select the channel(s) in Trigger Channel for full screen monitoring.
6.4.2
Congure Buzzer
When an alarm is detected, the buzzer will make an audible beep.
Steps
1.
Go to System → Live View → General .
2.
Check Enable Audio Output.
3.
Set the audio volume.
4.
Click Apply.
5.
Go to Linkage
Acon interface of the alarm detecon (e.g., moon detecon, video tampering,
face detecon, etc.).
6.
Select Buzzer as the alarm linkage
acon.
Digital Video Recorder User Manual
92