HIKVISION iDS-9000HQHI-M8/S Series - Call a Pattern; Set Linear Scan Limit

3.6.7 Call a Paern
Follow the procedure to move the PTZ camera according to the predened paerns.
Steps
1.
Click on the quick sengs toolbar of the PTZ camera's live view.
2.
Click
Paern to congure paern.
Figure 3-20 Paern Conguraon
3.
Select a paern.
4.
Click Call to start the paern.
5.
Oponal: Click Stop to stop the paern.
3.6.8 Set Linear Scan Limit
Linear Scan trigger a scan in the horizontal direcon in the predened range.
Before You Start
Make sure the connected IP camera supports the PTZ funcon and is properly connected.
Note
This funcon is supported only by certain models.
Steps
1.
Click
on the quick sengs toolbar of the PTZ camera's live view.
2.
Click direconal buons to wheel the camera to a locaon, and click Le Limit or Right Limit to
link the
locaon to the corresponding limit.
Note
The speed dome linear scans from the le limit to the right limit, and you must set the le limit
on the le side of the right limit. Also, the angle from the le limit to the right limit must be not
greater than 180º.
Digital Video Recorder User Manual
40