HIKVISION iDS-9000HQHI-M8/S Series - Add Network Camera Via Customized Protocol

4.
Oponal: Check Use Channel Default Password to use the default password to add the camera.
5.
Oponal: Check Use Default Port to use the default management port to add the camera. For
SDK service, the default port value is 8000. For enhanced SDK service, the default value is 8443.
Note
The funcon is only available when you use HIKVISION protocol.
6.
Oponal: Check Verify Cercate to verify the camera with cercate. The cercate is a form
of
idencaon for the camera that provides more secure camera authencaon. It requires to
import the network camera cercate to the device rst when you use this funcon. For details,
refer to .
Note
The enhanced SDK service is only available when you use HIKVISION protocol.
7.
Click Add.
8.
Oponal: Check Connue to Add to add other network cameras.
1.7.3 Add Network Camera via Customized Protocol
For network cameras that are not using standard protocols, you can congure customized
protocols to add them. The system provides 16 customized protocols.
Steps
1.
Go to More
Sengs → Protocol .
Figure 1-14 Protocol Management
Digital Video Recorder User Manual
14