HIKVISION iDS-9000HQHI-M8/S Series - Chapter 10 Network Settings; Configure DDNS; Configure Pppoe

Chapter 10 Network Sengs
10.1 Congure DDNS
You can set Dynamic DNS service for network access. Dierent DDNS modes are available: DynDNS,
PeanutHull, and NO-IP.
Before You Start
You must register the DynDNS, PeanutHull, or NO-IP services with your ISP before conguring
DDNS sengs.
Steps
1.
Go to System → Network → TCP/IP → DDNS
Figure 10-1 DDNS Sengs
2.
Check Enable.
3.
Select DDNS Type as DynDNS.
4.
Enter Server Address for DynDNS (i.e., members.dyndns.org).
5.
Under Device Domain Name, enter the domain name obtained from the DynDNS Website.
6.
Enter User Name and Password registered in the DynDNS Website.
7.
Click Apply.
10.2
Congure PPPoE
If the device is connected to Internet through PPPoE, you need to congure user name and
password accordingly under System → Network → TCP/IP → PPPoE .
Digital Video Recorder User Manual
113