HIKVISION iDS-9000HQHI-M8/S Series - Configure Enhanced VCA Mode; Face Picture Comparison; Facial Detection

1) Click Edit.
2) Oponal: Check Enable of Display Status and Nofy Surveillance Center.
3) Set Start Time of video to analyze.
4) Click OK.
4.
Check cameras and click Enabled to start analyzing.
Task status includes 3
condions: Disabled, Waing, and Enabled.
●
Disabled: No analysis task is enabled on the camera.
●
Waing: The analysis task of the camera is enabled. Device is waing to analyze data.
●
Enabled: The analysis task of the camera is enabled and device is analyzing data of the
camera.
5.
Oponal: For Non-Real-Time Face Picture Comparison analysis mode, click View Record to view
the progress of each day.
5.2
Congure Enhanced VCA Mode
Enabling enhanced VCA mode will maximize the connectable channel number for line crossing
detecon and intrusion detecon. However, it will disable 2K/4K HDMI output resoluon and 4
MP/5 MP/8 MP signal input for HUHI-K series. And for HQHI-K series, it will disable CVBS output
and channel-zero encoding.
Go to System → General , and check Enhanced VCA Mode.
5.3 Face Picture Comparison
The device supports the face picture comparison alarm and face capture for the connected camera
based on face
recognion feature.
Note
The chapter is only available for certain models of iDS series.
5.3.1 Facial Detecon
The facial detecon detects the face appearing in the surveillance scene. Linkage acons can be
triggered when a human face is detected.
Steps
1.
Go to System → Event → Smart Event .
2.
Click Face
Detecon.
Digital Video Recorder User Manual
62