HIKVISION iDS-9000HQHI-M8/S Series - Page 94

Figure 5-6 Line Crossing Detecon
3.
Select a camera.
4.
Check Enable Line Crossing Detecon.
5.
Set the line crossing detecon rules and detecon areas.
1) Select an Arming Area.
2) Select
Direcon as A<->B, A->B, or A<-B.
A<->B
Only the arrow on the B side shows. When an object goes across the
congured line with
both direcons can be detected and alarms are triggered.
A->B
Only the object crossing the congured line from the A side to the B side can be detected.
B->A
Only the object crossing the congured line from the B side to the A side can be detected.
3) Set the
detecon sensivity. The higher the value is, the more easily the detecon alarm can
be triggered.
4) Check Target
Detecon as Human or Vehicle. Only the target of selected type will trigger the
alarm.
5) Click Draw Area.
6) Draw a virtual line in the preview window.
7) Set the Max. Size and Min. Size for valid target object size. Targets smaller or larger than the
valid target size will not trigger
detecon.
6.
Set the arming schedule. Refer to Congure Arming Schedule .
7.
Set linkage acons. Refer to Congure Linkage Acons .
8.
Click Apply.
Digital Video Recorder User Manual
70