241
_____________________________________________________________________
12.3 Settings on the File Screen
______________________________________________________________
Selected file
Select a file.
Flashing cursor
NOTE
Saved data is loaded in this order: analog channels 1 through 4,
and then logic channels A and B.
When the one channel is specified as the load destination for
data from multiple channels, data is read to that channel
repeatedly, so that only the last data loaded remains.
The amount of time needed to load the data is determined by the
recording length and the number of channels.
Channels cannot be selected when loading X-Y combined
plotting waveforms and waveform of time-series harmonic
analysis are saved with the Recorder function.
(2) Select the file for loading data.
Using the cursor
buttons, select the file for loading
data from the file list. You can select files in multiples of
ten using the
/ button, and multiples of one hundred
using the
/ button.
(3) Select the channel for loading data
1. Press the
START
button to display the Channel Selection
Screen for the loading destination.
2. Move the flashing cursor to the position shown in the
figure and specify the channel from which to load the saved
data using the
buttons.
To Next Page
Loading...
