Hioki 8807-01 - Page 266

242
_____________________________________________________________________
12.3 Settings on the File Screen
______________________________________________________________
Flashing cursor
Refresh
Clears the screen and read waveform.
Overwrite
Reads the waveform without first clearing the
screen. Overwriting is possible only when both
the function and time axis range are the same.
Load
Loaded
p
art
Load
(4) Select New or Overwriting Load
(Refresh/Overwrite)
Move the flashing cursor to the position shown in the
figure below and use the
buttons to make a setting.
If the recorded length of the saved data is longer than the
recording length set in the product, the saved data is loaded
for the set recording length, and the remainder of the data
is not loaded.
If the recording length set in the product is longer than the
saved data, the data from the end of the last saved
waveform to the end of the product recording length is
invalid.
(5) Execute loading.
Press the
START
button to load, and press the
STOP
button
to cancel.