1
2
(Open/confirm the setting information.)
Select the data you want to save.
Setting options (∗. default setting)
(*1):After you select the data, “(after meas.)” is displayed
for the High-speed Function and “(realtime)” is displayed
for the Real-time Function. (If you select [Off], proceed to
step 8.)
Off∗, Waveform(*1), CSV(*1), Calc(after meas.),
Waveform + Calc, CSV + Calc
In the following steps, use the same operation to con-
figure settings.
2
3
4
5
Select the [Setting] screen.
For real-time saving, this field dis-
plays an approximate time of which
in length the storage device insert-
ed in the instrument can store data.
3 When you want to specify the name of the
waveform file:
Specify a name in [File Name].
See: "4.10 Entering Comments and Titles" (p. 128)
If left blank, file names are created automatically.
See: "Appendix 3 File Naming" (p. A12)
4 When you want to use both a CF card and
USB flash drive:
Set [Media (Preferred Save Location)].
(default setting: CF)
If you selected [Calc (after meas.)] for the data to
save, proceed to step 8.
5 Set [Deleting (Delete while Saving)].
Select the desired operation when removable storage
becomes full while saving.
Setting options (∗. default setting)
Off∗
Saving ends when the removable storage is near-
ly full.
On When the free capacity of the removable storage
reaches a certain minimum size, waveform files
are deleted, oldest first. If deletion is not possible,
saving stops.
A file other than a waveform file is not applicable
for deletion. (Numerical calculation file, setting
configuration file, file created with other than
MR8880-20, etc.)
In the case of CSV (real time),
saving is possible when the re-
cording interval is set to 5 ms or
longer.
If the storage media set as the
preferred save location be-
comes full, the data will be au-
tomatically saved to the other
storage media.
To Next Page
Loading...
