4.2 Viewing Power Measurements, and Changing the Measurement Configuration
54
Setting from the [Input] Page of the Setting Screen
When measuring multiple channels with a Wiring mode other than 1P2W, all channels
are forced to the same range. In this case, the range of each channel is set to match
the channel set to the lowest range.
Display the
[Input] page
Press the RANGE keys to
select the range
(Changes the selected [U range]
or [I range])
Select the
channel to change
To change the [U range] or [I range], select it with the
cursor and press , , or to change
the range.
About [All CH Set], see "2.2 Basic Operations"
(p. 18).
To Next Page
Loading...
