Hioki RM3542 - Device-Specific Commands

9.7 Message Reference
127
9
(1) Event Status Register
Device-Specific Commands
Set and Query Device-Specific Event Status Enable Register ESER0
Syntax
Command
:ESE0 <0 to 255 (NR1)>
Query
Response
:ESE0?
<0 to 255 (NR1)>
Description
Command Sets the mask pattern in Event Status Enable Register 0 (ESER0) for the Event
Status Register.
Note
Data initializes to zero at power-on.
128 64 32 16 8 4 2 1
bit 7bit 6bit 5bit 4bit 3bit 2bit 1bit 0
unused OR ERR Hi IN Lo INDEX EOM
Read Device-Specific Event Status Register ESR0
Syntax
Query
Response
:ESR0?
<0 to 255 (NR1)>
Note
Executing ESR0? clears the contents of ESR0.
Set and Query Device-Specific Event Status Enable Register ESER1
Syntax
Command
:ESE1 <0 to 255 (NR1)>
Query
Response
:ESE1?
<0 to 255 (NR1)>
Description
Command Sets the mask pattern in Event Status Enable Register 1 (ESER1) for the Event
Status Register.
Note
Data initializes to zero at power-on.
128 64 32 16 8 4 2 1
bit 7bit 6bit 5bit 4bit 3bit 2bit 1bit 0
unused unused unused unused VOLT CURR CE Hi CE Lo
Read Device-Specific Event Status Registers ESR1
Syntax
Query
Response
:ESR1?
<0 to 255 (NR1)>
Note
Executing ESR1? clears the contents of ESR1.