Hioki RM3542 - Initializing (Reset)

5.7 Initializing (Reset)
67
5
The instrument can be reset by three methods.
• System reset from the System screen: Returns all settings (except the clock) to factory defaults.
• Turn the instrument on while simultaneously holding the REF% and ABS keys: Returns all settings (except
the clock) to factory defaults.
• Reset by remote control command: returns all settings (except communication and clock settings) to their
factory defaults.

RST command (non-backup, (p. 123))
:SYSTem:RESet command (p. 137)
This procedure describes system reset from the System screen.
5.7 Initializing (Reset)
1
Open the Basic Settings screen.
2
Open the System screen.
3
Select RESET.
4
Select whether to cancel or proceed to execute system reset.
The Measurement screen is displayed when system reset finishes.
The Basic Settings screen appears.
The System screen appears.
[SYSTEM]
1
Selection
2
Selection
1
2
Returns all settings to their factory
defaults
Cancel the operation
Execute