Hioki RM3542 - Chapter 6 Storing and Exporting Data

69
6
Measured values can be stored or automatically exported, according to application. Stored data can
be output to a printer, RS-232C or GP-IB. Also, statistical calculations can be applied to internally
stored data.
Storing and
Exporting Data Chapter 6
Store up to 30,000 measured values using the EXT I/O TRIG
signal or by pressing F4 [MANU] on the Basic Settings screen.
Data Memory Function (p. 70)
Store measured values at spe-
cific times.
This is convenient for batch exporting
data to a controller while switching
reels.
Measured values are automatically stored as they become sta-
ble.
When the specified number of data points (up to 99) is acquired,
the beeper sounds and auto-storing halts.
Auto-Memory Function (p. 71)
Store data after measured value
has stabilized.
This is convenient for sample inspec-
tion after printing (vapor deposition)
resistors on a board.
Minimizes transfer time by eliminating the need for transmit re-
quests from the remote controller. (RS-232C interface only)
Data Output Function (p. 77)
Automatically output (export)
measurements at the end of
measurement.
Stored measurements are lost when the instrument is turned off.
Therefore, be sure to print out or export important data to a PC.