Task-Oriented Reference
1
Task-Oriented Reference
To minimize measurement error
Setting the measurement speed (p. 29)
Setting the measurement speed integration time option (p. 44)
Zero-adjustment (p. 32)
To judge measurement results
Judge measured values (comparator function) (p. 34)
Compare the measurement settings of two instruments
(Settings Monitor function) (p. 53)
To correct faulty measurements
Confirm faulty measurement (p. 38)
Improve probe contact (Contact Improver function) (p. 47)
Test for short-circuited probe (probe short-circuit detection
function) (p. 51)
Compare the measurement settings of two instruments
(Settings Monitor function) (p. 53)
To automatically store measured
values
Store as soon as measurement is stable
(Auto Memory function) (p. 71)
To print measurement results Printing (p. 79)
To measure by PLC connection
(PLC: Programmable Logic Controller)
External control (p. 85)
Communications (RS-232C/GP-IB interface) (p. 97)
To connect to a computer Communications (RS-232C/GP-IB interface) (p. 97)
To automatically send measure-
ment data to a computer
(RS-232C interface only)
Export measurement values automatically
(when finished measuring) (p. 77)
To check operation
Setting Measurement Start Conditions (Trigger Source) (p. 30)
Internal trigger (INT)
Calibration (p. A11)
To Next Page
Loading...
