2.1 Connecting the Power Cord
22
2.1 Connecting the Power Cord
• Before turning the instrument on, make sure the supply voltage matches that indi-
cated on its power connector. Connection to an improper supply voltage may dam-
age the instrument and present an electrical hazard.
• To avoid electrical accidents and to maintain the safety specifications of this instru-
ment, connect the power cord only to a 3-contact (two-conductor + ground) outlet.
• Before using the instrument, make sure that the insulation on the power cord is
undamaged and that no bare conductors are improperly exposed. Any damage
could cause electric shock, so contact your dealer or Hioki representative.
To avoid damaging the power cord, grasp the plug, not the cord, when unplugging it from the
power outlet.
Rear Panel
1 Confirm that the mains supply voltage matches the
instrument, and connect the power cord to the power
inlet on the instrument.
2 Plug the power cord into the mains outlet.
The POWER button on the front panel lights red.
In event of a power outage, operation resumes with the same
settings when power is restored (breaker reset, etc.).
Power inlet
To Next Page
Loading...
