Chapter 10 Specifications
171
10
(10)Current Mode Setting
(11) Zero Adjustment
(12)Measurement-Start Logic Setting
(13)EOM Pulse Width Setting
(14)Data Output Function
(15)Output Data Format Setting
(16)Comparator Beeper Setting
(17)Key-Press Beeper Setting
Operation Enable if measurement current flows when not measuring. (for each range)
The CONT (continuous) setting is available only when the Contact Improver function is
disabled.
Default state PULSE
Setting CONT/ PULSE
Operation Nullifies wiring resistance when measuring with the two-terminal method.
Default state OFF, 0
Adjustment range -1 to 10
Operation Sets TRIG signal logic for EXT I/O
Default state ON edge
Setting OFF edge/ ON edge
Default state PULSE
Pulse width 5 ms
Setting HOLD/ PULSE, 1 ms to 100 ms
Operation Measured values are automatically output when measurement is finished.
Default state OFF
Setting ON/ OFF
Default state ASCII
Setting ASCII/ BINARY
Default state OFF, HIGH, or LOW
Audibility ON/ OFF
Signaling criteria HIGH/ LOW/ HIGH or LOW/ IN
Default state ON
Setting ON/ OFF
To Next Page
Loading...
