Chapter 10 Specifications
175
10
RS-232C
Communication contents Remote control, measured value output (export)
Transfer method Asynchronous, Full duplex
Transmission speed 9,600bps (default setting)/ 19,200bps/ 38,400bps
Data length 8 bit
Stop bit 1
Parity none
Delimiter Transmit CR+LF, Receive CR or CR+LF
Handshaking No X-flow, no hardware flow
Protocol Non-procedure
Connector Male 9-pin D-sub, with #4-40 attachment screws
Printer
Printing Contents Measurement data (PRINT signal input), Total data count, Mean, Minimum value (sam-
ple no.), Maximum value (sample no.), Standard deviation of sample, Population stan-
dard deviation, Process capability, No. of IN, No. of Hi and Lo, No. of OvrRng, No. of
Measurement faults
Communications Communications method Asynchronous RS-232C
Transmission speed 9,600bps
Data length 8 bits
Stop bit 1 bit
Parity none
Delimiter Transmit CR+LF, Receive CR or CR+LF
Handshake No X-flow, no hardware flow
GP-IB interface (RM3542-01 only)
Communication contents Remote control
Interface Functions SH1 All Source Handshake functions are supported.
AH1 All Acceptor Handshake functions are supported.
T6 Basic talker functions are supported.
Serial poll function are supported.
No talk-only mode.
The talker cancel function with MLA (My Listen Address) is supported.
L4 Basic listener functions are supported.
No listen-only mode.
The listener cancel function with MTA (My Talk Address) is supported.
SR1 All Service Request functions are supported.
RL1 All Remote/Local functions are supported.
PP0 No Parallel Poll function.
DC1 All Device Clear functions are supported.
DT1 All Device Trigger functions are supported.
C0 No Controller functions are supported.
Miscellaneous Conforms to IEEE 488.2
Settings Monitor terminal (SET MONITOR)
Connector Male 9-pin D-sub, with #4-40 attachment screws
Connection cable Crossover
To Next Page
Loading...
