CHECKING AND SERVICE OF REAR
SUSPENSION
1. It is similar to the front suspension ,Check if
there exists any distortion or crack on the install
axis of the shock absorber in which case it must be
replaced.
2. Inspect the rocker bushing and the middle
rubber separate is integrant.( According to the front
Suspension)
3. The cotter pin on the head of the install axis
which in the rear shock absorber whether is
credible.
NOTE:
After disassemble the rear shock absorber,
check if there exists any distortion or crack on
the frame connection hole and the rear shock
absorber, if so, inform the special serviceman
to inspect and service first or install the rear
shock absorber on the frame after
instead.(Attention, the bolts must be the
special self-lock nut, the fastening torque must
be 45-55Nm)
To Next Page
Loading...
