CHECKING THE RADIATOR
1. Check:
• radiator fins
Obstruction
Clean.
Apply compressed air to the rear of the radiator
Damage
Repair or replace.
NOTE:
Straighten any flattened fins with a thin,
flat-head screwdriver.
2. Check:
• all rubber hose
Cracks/damage
Replace.
3. Check:
• Bolt clip
the tightness of Bolt clip. If loosen, please have
the hoop tightened immediately.
4. Check:
• radiator fan
Damage
Replace.
Malfunction Check and repair.
5. Measure:
• radiator cap opening pressure
Below the specified pressure
Replace
the radiator cap.
Radiator cap opening pressure
107.9 ~ 137.3 KPa
(1.079 ~ 1.373 kg/cm
2
, 15.35 ~ 19.53 psi)
a. Install the radiator cap tester ① and adapter
② onto the radiator cap ③.
b. Apply the specified pressure for ten sec-onds
and make sure that there is no drop inpressure.
To Next Page
Loading...
