Maintenance mode OFF for CB 520A A1, CB 520H A1/B1/B2/B3/B4, CB 540A
A1/B1, and Non-SMP CB 520X B1/B2/B3
1. Select Resources tab and select Modules > All Modules > Server
blades > a target blade that should be changed into maintenance
mode.
2. Click Action, and then select Maintenance mode OFF.
3. The current setting condition will be displayed. Click Confirm.
4. The confirmation dialog box appears. Click OK.
5. Confirm that the highlight of the selected module goes out and the
message is off.
Note: The server blade cannot boot OS as long as Maintenance mode ON is
activated.
Maintenance mode ON for SMP CB 520X B1/B2/B3
1. Select Resources tab and select Modules > All Modules > Server
blades.
2. Click Action, and then select Maintenance mode ON.
3. Click check boxes of the SMP blades that should be changed to
maintenance mode, and then click Confirm.
4. In Confirm dialog box, click OK.
5. Confirm that the selected blades highlighted and a symbol is indicated.
4-12
Common process for replacement
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
