Hitachi CB 520H A1 - Removing a Switch Module Dummy Module; Removing a Management Module Dummy Module; Removing a Power Supply Dummy Module

Removing a switch module dummy module
1. Put on an anti-static wrist strap.
2. Pull out the switch module dummy module from the bay while releasing
the lock tab as shown below.
Figure 5-161 Removing a switch module dummy module
Removing a management module dummy module
1. Put on an anti-static wrist strap.
2. Pull out the management module dummy module from the bay while
releasing the two lock tabs as shown below.
Figure 5-162 Removing a management module dummy module
Removing a power supply dummy module
1. Put on an anti-static wrist strap.
2. Pull out the power supply dummy module from the bay while releasing
the two lock tabs as shown below.
5-128
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual