4. Install mezzanine cards on server blade if you need. See "Installing a
mezzanine card on page 5-52" section.
Supported combination of mezzanine cards is as same as CB 540A A1/B1.
5. Close the top cover.
6. Insert server blade to the chassis. See "
Installing a half-wide server blade
on page 5-5" section.
Updating IPL file of LOM for CB 520H B3/B4 or CB 520X
B1/B2/B3
Note: Previously if you had set Personality of LOM to NIC+RoCE, and you will
fail to update IPL file of LOM. Update IPL file of LOM after setting Personality
of LOM to NIC from NIC+RoCE.
1
. Connect the remote console. See "
Connecting the remote console on page
8-2" section.
2. Start Compute blade test program (CBTP). See "Starting Compute blade
test program (CBTP) on page 8-6" section.
3. Move cursor onto Utility by using Tab key on the CBTP main menu, and
then press Enter key.
4. Move cursor onto F/W update tool by using Tab key on the Utility
menu, and then press Enter key.
10-14
Change LOM configuration
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
