Hitachi CB 520H A1 Service Manual

Figure 9-2 Start the updated firmware
Note: Do not power off the server blade during updating the firmware.
Updating firmware on management module
Tip: Before performing the following procedures, you must download the
updated firmware file from Hitachi Data System support portal to the console
PC.
Notice:
Restriction: Firmware on Management module before ver. A0145 does
not support disabling LOM on CB 540A A1/B1. If you want to backdate
ver. A0145 or earlier on CB 540A B1, enable LOM according to change
LOM configuration procedure. See "Chapter 10, Change LOM
configuration".
1
. Select Resources tab and select Modules > Management Modules.
2. Click Action and then select Update Firmware.
3. The update dialog box is displayed. Check Update that you should update
the data.
4. Click Browse and select the new firmware file.
5. Click Confirm.
Updating firmware
9-3
Hitachi Compute Blade 500 Series System Service Manual

Hitachi CB 520H A1 Specifications

General

Brand	Hitachi
Model	CB 520H A1
Category	Server
Language	English