No. Name State Description
4 Reset switch (RST) - Press and hold for five seconds to reset the
LAN switch module.
5 Power LED (PWR) Green-On Powered-on, normal operation.
6 Status1 LED (ST1) Green-On Normal operation.
Green-Blink Power-on diagnosis or software activation.
Red-Blink Fault. Maximum temperature limit exceeded
or other warning.
Red-On Alarm.
7 Identify LED (LOCID) Blue-On The switch module is identified.
1/10Gb LAN switch module
Figure 1-44 1/10Gb LAN switch module
Table 1-36 LEDs and connectors on 1/10Gb LAN switch module
No. Name State Description
1 LAN ports 1 to 4 Green-On Link is established
Green-Blink Link activity. Port is sending or receiving data.
Amber-On Link failed.
2 10GBASE-R slots - Slots for 10GBASE-LR or 10GBASE-SR
transceiver: Each slot has a link LED on the
upper right and a TX/RX LED on the lower
right.
3 Memory Card slot (MC) - Slot for SD memory card.
4 Access LED (ACC) Green-On The SD memory card is accessed
5 Reset switch (RST) - Press and hold it for about five seconds or
more, reset the module.
6 TX/RX LED for XFP Green-On A link is established on 10BASE-R and the
port is sending or receiving data.
Off The port is neither sending nor receiving data.
7 LINK LED for XFP Green-On A link is established on 10BASE-R.
Introduction
1-33
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
