USB port Location indicator
port 1 port 2 port 1 port 2
Installed N/A /dev/sdb N/A
N/A Installed N/A /dev/sdb
Installed Installed /dev/sdb /dev/sdc
1. Put on an anti-static wrist strap.
2. Remove the target server blade. See Removing a full-wide server blade
on page 5-6 section.
3. Open the top cover of the server blade. See Opening a top cover, Server
blade on page 5-38 section.
4. When a mezzanine card is installed in mezzanine slot #4, remove the
mezzanine card. See Removing a mezzanine card on page 5-51 section.
5. While pressing the purple colored button, pull out the USB from the USB
slot.
Figure 5-74 Removing a USB
Installing a USB
1. Put on an anti-static wrist strap.
2. Reverse the removal procedure.
Replacing a SD card enablement kit and SD card in CB 520H
B3/B4
This procedure describes how to replace the SD card enablement kit and SD
card from CB 520H B3/B4.
5-60
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
